hull I looked at the parker design and it intregues me.I would like a hull like this as a self bailing center console.you said I would have to...
ruel parker where do I obtain info on ruel parker designs,picts etc.
panga I looked at a large panga but it was powered by twin 200s,Just dident seem economical to operate.
Due to the fuel prices today I am looking to trade in my high hp deep v for a more economical to run hull like a sharpie , a mullet skiff or a...
dry out the hull has been out of the water for a year and a half so im assuming its dry.the glass is ok but the gellcoat flaked off in some spots...
barrier The gelcoat is in need of some repair alot came off with the old paint
I made an appointment to have the bottom media blasted.After that can i paint with epoxy resin then bottom paint.Or what should I use?
level This one was easy the engines were in the middle but fuel was in the rear.Now outboards in the rear and 320 gal fuel capacity in the middle.
conversions I have done the inboard to outboard conversion many times before and When you move the weight around right there are no problems.Ive...
speed the hull speed will only be 30 to 35 mph max.Cruise will be approx 25mph.
load bearing the transom has been reinforced to accept outboards because the load use to be applied to the stringers via the inboard engine.The...
The outboards bolted to a transom 3'' thick composit.The nidacore is just to fill the hole in the bottom where the shaft use to exit.
I am converting a inboard hull to outboard power and while filling in the 16in by 25in hole cut in the bottom I screwed up.I cut a piece of 1/2...
I Came Across A 45 Carricraft Hull For The Price Of The Transport.the Cabin Is Shot But The Hull Is Sound.this Would Make A Huge Fishing Platform...
now the design Thanks For All The Help With The Materials And Required Reading.the Hull Im Looking To Build Is Similar To The Vietnam Riverine...
ply with ply what thickness should be used to cold mold a hull.i wanted to use 3/8 if luan wouldent work.2 layers on sides four on bottom covered...
I am located in long island ny and can not locate a supply of aluminum tube to modify a top i purchased for my boat.Can i use 6061t6 and just...
thanks it time to sign up for classes in south hampton college.
Building A Boat Im Trying To Build A One Off Hull That Is Strong And Low Maintence That Doesnt Weigh A Ton But Doesnt Have To Be A Featherweight...
mold? I just thought the luan would space the glass further apart and therefore add stiffness.I just finished some work on a pacemaker with...
