I have been approched by a person wanting to buy one of my Hull molds, Having never sold one I have no idea what to ask for it, Its in perfect...
Hi folks I would like to open a discussion on transom coring. a transom must support a outboard motor in many styles and horse powers,, are folks...
Hi Folks I have a plug built for an 18' x 6' -6" outboard powered skiff,, My question is in using 2oz csm and 24 to 25 oz fabric who many layers...
I have a new project where I am wanting to build a curb,frame or ring if you will to set a console, I will be glassing it to the boats deck ten...
I am looking for an affordable unit that will not cost an arm and a leg, yet effective Any thoughts?
I have been at this awhile and had a problem with a hatch lid,, it is 20" x 36 here is what I did.. using a well waxed peice of aluminum and...
I have been told never to use a mechanical polisher to remove wax in a mold, can anyone tell me if there has been any technological break through...
I have bagged a good many FRP parts, mostly hatch frames. ! My question is can the baby blanket breather be used as a bleeder or should I have a...
I picked this up at an auction , and would like to get it ready for service, can anyone help me with operation manuals
deleted
I have a ES dump gun can anyone tell me is the SOLO V32-006 cups fit the lid? found some very cheap! if not these can you tell me the model that...
I am looking at a product called versi -foam its a 2# destiny closed cell material more over looking for the calculation to figure where I stand...
I work with polyester resin and am looking for a good hot weather hardener, love to hear what you think !
when building short run molds I use dura-tec to surface and polish to pull the part from , does anyone have a suitable product that is cheaper I...
I have noticed a bit or questions here about this subject. I would like to see a thread dedicated to building tooling and production molds, I...
is it possibleand how wouldI infuse a 1/2" foam core with a skin of 1708 on each side on a flat mold? does the foam need to be "hot coated or...
Hello friends, I have a question, In gel coating a small two part mold, (its a box style thing with about 23" long by 16" wide, the bottom is open...
hello I am seeking data on what a shop charges per hour for a fiberglass tech. capable of replacing a transom on an outboard boat,, and stringer...
I know this is not the market place but I thought I'd toss this out here as one of you may have one laying around and might consider selling it!...
HEllo all, I have a 23' o/b powered boat that I build I am looking to bring her to about 25' with an intergal engine bracket, I would extend the...