OK, let's get onto a better understanding, of each other and of the concept. First of all there are no mechanical parts to the system, no...
Hello Tunnels, thanks for your input and the good humour, appreciated.
Forgive me for raising your ire Mr E, but I'm the sort of bloke who "measures twice and cuts once". In this case the measuring was an attempt to...
Thanks for the above MechaNik, valued and appreciated, particularly the equation re pressure, area and Newtons. As for circular motion there's...
A heartfelt apology for my posts, all of them. They will be deleted. Ah, well, we all have bad days, apology accepted... My first post was a...
We'll do that Tom, the signal to noise ratio in here aint worth the bother.
Thanks for that Bob. Not a problem Tom, seems it's easier to get on the wrong side of folks than to get on the right side of them... Propellers...
pistnbroke how apt is that !!!
Could have responded better...
I hope that helps and I genuinely hope you've had a stroke, of genius. Thanks. That is a rare thing these days. Aint it just ;)
Hmmm, looks like I unintentionally started a grass fire in here, I have no appetite to stir controversy, conflict, disrespect or sarcasm at all,...
I regret that my posts caused you frustration Tom, that wasn't my intent. As for exchanging PM's Tom the offer is appreciated, but due to the...
LOL, aye, well, humour is appreciated ;) I will attempt to say more, and to explain why I can't "disclose" all.
Thanks for the above Mr E, appreciated... The thing is, I think I have developed a way to push a boat in such a way that there would be little...
Hello Tom... Looks like I have upset you, that wasn't my intention, I regret that, and I offer my apologies to one and all if any of my...
Hello Landlubber, thanks for your input, maybe you can help me on this one... Using the concept of a push plate outlined earlier, which method...
Thanks again Tom for your input, wish I could say more, even though like most projects many of them finish up as just a pile of sawdust, but, you...
Hello Tom, I'll be working on this project the next couple of months, a bit short of water at the moment as it's -10C round here {in Nova Scotia}...
Right then, in an attempt to clarify the picture a little, here goes... To give you guys a better idea of the concept {without describing the...
248.3 sq inches... Right then, I guess that torque comes into this somewhere ? to turn a paddle that size ? The thing I'm trying to get at Tom...
