I was exposed to a flourescent penetrant process once. We manufactured fuel tanks for a customer who wanted the welds tested. We hired a guy to...
Alternatively, you MIGHT be able to use a die penetrant kit. I did not mention this earlier because I considered that a scratch on the mast might...
Top Techniques Used in NDT for Aluminum Welding | Zetec...
As Comfisherman said, this is a popular boat design on the westcoast as you have a cabin to get out of the rain, good 360 vis in the cabin. Most...
I see that there is another glass boat in the picture. Do you think that the place looked like a company that builds boats Ie were there other...
Specmar has designs for various aluminum landing craft that would fit your SOR Their fees include using their CAD cut files for one boat. As...
What part of Canada are you from? Were you visiting Alaska when you saw it?
Unknown, certainly not at 15 knots but you could also put a 200 hp motor on the back, with simple steering and have Serenity tow. The combination...
https://www.boatdealers.ca/boats-for-sale/537088/erwin-manufacturing-ltd-packing-barge-work-platform-fort-langley-british-columbia $55k Canadian...
In this forum, it occurs so frequently that answers are much more complicated as what would appear on the surface. Especially the neophyte OP's,...
At first look, it made sense as a good guess due to extra mass when loaded but "When fully loaded, the ship sits about two-thirds underwater or...
No, I ran across this when I was just looking for picture that I have seen of an unloaded tanker that due to not carrying weight with half of the...
I was originally going to post this on a current thread but decided that the topic/question may be of interest to more people. Surface drives are...
The reason for the curve provides a place for pressure recovery to occur and help move the boat along. If the boat has a rectangular cross...
Not sure why I have to justify the ability to offer a response as I basically put forth a simple question as to your assertation that the...
The oxidation of aluminum is as follow: ( at least according to the three of the sites that I looked for the actual chemical equation) Al(s) +...
A good point On our first 21 foot jet boat build, we used 3/16 on the bottom. Due to distortion in welding, we had to add additional stringers to...
You had originally mentioned that you were considering Mig on the initial inside welds and tig on the outside. Mig and Tig welding speed in...
I think that you misunderstood my query. It appeared that KapnD had some method of determining "a proper engine level" without using the factory...
If you need to know what is the correct amount of oil, which may not be near the full mark on the dipstick, how do you determine this amount?