Thank you both for replying.
If 3 ozs of epoxy has a pot life of 60 minutes, is there a way to determine pot life for larger quantities, with temperature and container shape...
Thanks.
I like it! What does the red image represent?
That is so cool!
My problem, and yes it's a big problem, is my mind plans out better than it executes.
That's impressive. Have fun!
About how many hours have you logged building your boat? It's a great looking boat.
Thank you. I have a Carolina Skiff. The bottom and bow are similar. No tunnel. I'm sure you have been in this type boat. If not, do not make any...
I've enjoyed this thread. What's the purpose of the hose in the bottom of the hull? Alan
[ATTACH] [ATTACH] From my experience, wax is more predictable than spraying PVA. Stoner's Miracle Wax is what I use. The company recommends to...
I also have the book you are using. I have built two canoe molds. The first was a 17' male mold from my own design. I never completed the female...
Thank your for your replies fallguy.
Thank you. The resin line runs along the bottom and the vacuum line runs around the flange. The reinforcement stops about five inches from where...
I am fixing to infuse my 12' canoe mold. Yes, this has been "going to infuse my 12' canoe mold" for quite some time now. It has been recommended I...
I will use two oil radiator heaters inside the mold and cover with blankets. I will do a generic post cure.
The epoxy retailer is US Composites and there is no detailed information on the resin other than the following: Mixing Ratio by Volume: 2:1 Pot...
Thanks for replying. My question has to do with the time immediately after the infusion has completed. Should the cure temperature be within a...
Tomorrow I will finally infuse the 12' canoe I have been working on for years. I'm going to preheat the mold and I want to elevate the temperature...
I'm waiting to recover from foot surgery before finishing my resin infusion project (a 12' canoe). What are you infusing? From what I have read, a...