Trying not to add fuel to the flame but to answer the question posted to me by whoosh. I have been welding for the past 18 years and i have...
Gentlemen, It has been a little while since i last thanked you for your valuable input and offered some insight into how my quest is going....
Does anybody else feel that Ali would be a better option than steel? I have no problem being able to work Ali although i will have to brush up...
I have erred away from aluminum for several reasons; It work hardens More prone to stress cracking Higher distortion rate due to heat...
It wasn't but a nice addition to the thread I'm sure sir. I had the pleasure of a walk around a 40' Ganley today down at the marina and must...
Tad thats a nice looking design. I was wondering the diffrence for short handed sailing with a single mast over the two you are showing on this...
As i have neither owned, built nor sailed a Roberts i can not hand on heart give you an experienced answer. I can tell you what i have heard from...
Thanks Stan. I will pester people no end shortly.
Gentlemen thank you. I went away for a week with the family and have come back to quite a catch up. Before i go any further i would just...
Thanks guys some good food for thought. Those links Tad were excellent. Also did some digging with the Denis Ganley and have found a company in...
Thanks Tad now we are getting some conjecture. I will try to answer your points in order. Have gone for a larger boat due mainly to cabin...
We used those ceramic backing strips on the repair of an ENSCO drilling platform. For long welds they are a time saver but we didn't use them on...
Jarrod Well it is as good a path to take as any. I would like to outsource locally if i need to at all. I intend to use NZ profiles for all...
Excellent only 2 more posts to qualify for PM. I need to have been a member for 1 day and have posted 5 messages to access PM. I hope this...
Thats the sort of thing i have been looking at. Nice design. I have also looked at the Roberts New York 65 and a Dix 64. This is where i...
Well i don't normally do these introduction forum messages but here goes i have also posted this on another forum. I am in the 30ish year old...