Barrel boat frames are usually around 8' x 20' so I'm just wondering if the cons outweigh the pro's when using a earthen mold this size. Yes,...
I think the barrel boat guys might be interested in this because from the comments, most builders haven't heard of earthen molds.. I think you...
No, it's in the video I linked to
Hey folks.. I found a video on FB of Asians using soil and clay to form a mold for a good size work hull.. I'm still intrigued.. Has anyone...
You probably need to be a member of the group. From what Im gathering, he enlarged dumas 77 Atlas Van lines RC plans, and used a mercruiser...
Yeah, I think you would have to go bigger with a V8 and two seats.. Found this on facebook.....
Here's some plans.. Clark Craft - Boat Plans, Boat Supplies & Marine Epoxy...
Thought I might resurrect this 12 year old thread with a question.. Does anyone have any information about Jon Staudacher and his "THE ANIMAL",...
Thanks Guys.. I'm painting in shade and about 75 degree's. Its also about 55% humidity but the temperature and humidity rise when I open the...
Iv been rolling and tipping rustoleum topside thinned 10% with MS and valspar hardener at 16:1 and the finish is acceptable.. My problem is my...
Thanks for that Barry. My supplier said acetone, and Id probably be fine using that followed by denatured alcohol (both on hand) as long as...
Thanks.. Here's what Ive gathered.. The single stage coatings are compatible with spirits because they use spirits as the solvent.. The two...
When reading about surface prep for epoxy I keep hearing 80 grit and acetone is recommended. But if you read about surface prep in the auto...
Thanks PAR. Especially the part about adding cabosil last.. But I bet I'm not the only one who would like to know what, and what ratio's, you...
Thanks PAR. But without a basic or general starting point for a fairing compound for example.. I imagine allot of epoxy was wasted testing...
I have a epoxy repair project I plan on using cabosil, milled fiberglass and microballons as fillers. But I'm unsure of the ratio's. Iv read...
Thanks.. Iv ordered 1/4"-20 stainless rivnuts for the .25" grip range because I need four of them to strap my couch to the wall. The couch isn't...
Thanks. But the wall I need to fasten to has 2.5" X 3/4" X 1/8" 6061 aluminum studs. Meaning the trailer wall is less than 1" thick. I...
holy thread resurrection Hey people.. Its funny because I was searching for information on rivnuts again and came across my old thread..:)...
After waiting for the parts.. I installed a few SS nutsert/rivnuts to secure the ancra tie downs for the tool box. I might install another piece...
