Now going with individual windows, Thanks for the replies.
Cheers Jeff and Mike I am now going with separate windows :-)
Gonzo,The skin is 3mm mild steel I have cut all the rust affected areas out and re welded in new 3mm mild steel. TANSL Cheers
Hi all, I am after some feedback, I have a Steel John Pugh Winsong Yacht, she is 25 yo and the original windows were 10mm lexan bolted to the hull...
Thanks baeckmo, it will be a lot easier to take it to the day tank as it is above the engine. I really appreciate the advise. Cheers Cal
Hi all, refitting my Ketch with a new Nanni 4.50 engine and the fit instructions state that the fuel return should be 'Returned to below the...
Cheers guys
Hi all, I own a 40 ft Steel Centre Cockpit Ketch and I am in the middle of a refit and repower. Just starting to design the wet exhaust (See...
Cheers CDK :idea:
Hi all, I am after some advice I have a Nanni 55 hp engine that is designed for keel cooling, the manufacture recommends 1.85 sqr/mtr of surface...
Thanks Guys again some good advice and some great ideas. Cheers Cal
Thank you all for you replies. Teddy the 32mm pipe has an OD of 42.2mm which is a circumference of 132.6mm and 2 x 3.5 mtr lengths each side of...
Hi all, long time Lurker and researcher, I would like some advice on a Keel cooling set up. I am not interested in debating the pro’s and cons of...
Hi all, I hope you are all well. Seeking any feedback or experiences with Admiral Autopilot from HyDrive? In the process of fitting...
There is a John Pugh owners site at http://groups.yahoo.com/group/John_Pugh_Yacht_Owners Cheers and fair winds, Cal Windsong 39.5 S.V. All the...
Thanks Micheal and PAR, that is exactly the sort of feedback I was after, as I am in the early stages of planning I needed other perspectives on...
Hi all I am looking for some advice? I own a 40 foot cruising ketch and need to raise the height of the boom by 40 cm to improve headroom and also...
Hi all, a long time lurker and Steel 40 ft yacht owner here - ( She is a Ketch and weighs 12 Tonnes.) I would like some guidance from the forum...