Why is it that you're having trouble aligning the engine/shaft? Is the engine too high or too low or is it a side to side issure? All of these...
My fuel tanks are wing tanks mounted up high, so the installation is different than yours. I would go with 1/2" thick strips of hard rubber to...
Aluminum is your best bet. 3/16 5086 and you can weld it up in just a couple of days. Just make sure you pressure test before you put it in the...
Hey All, Does anyone know how to weld/glue fittings to polyethylene tanks? I usually use thru-hull fittings with lots of 5200, but I really...
Hi, Ya'll, I've got a customer with a Clipper Craft 30 with a scupper problem. Seems these were made by Clipper Craft and one of them is...
I think that the problem is not with the designs. It shouldn't be extremely hard nor expensive to design access to the machinery space. I...
Unless it's a large trawler type yacht with a single engine, most non-commercial boats need to be practically torn apart to remove most anything...
John, The only Grand Alaskan I've seen had two CATs for propulsion. If you're looking for reliability, you can't go wrong with the Detroit...
Years ago, I saw advertised a solvent for 5200. Never got a chance to try it and I don't see it advertised anymore so I guess it didn't work too...
Sorry, I posted too quick! I tried them on some of our boats a while back because the coxswains were tearing up the aluminum ones and I didn't...
Piranha Props makes a composite propeller for outboards. They are made of composite material with replaceable blades. http://www.piranha.com/
There's a special resin to use in fuel tanks. I can't remember the name, but most resin suppliers should know of some. It's easier to design the...