Thanks
I would like some elongation to be able to also use it close to outboards where there is more vibration. I have been reinforcing poly resin paste...
I am looking for a permanent structural adhesive recommendations for gap sizes up to 1/4- 3/8". I am currently glassing and finishing these joints...
I have a 28' female mold surfaced with polyester tooling gel. The side chines are tilted upwards at 5 degrees and I would like to fill them with a...
I have never used peel ply so forgive my ignorance So you are laying down the last layer of 1708, and while still wet, wetting out the csm and...
I would like to reduce the amount of fairing work on my 3 piece boats that have no glossy smooth inner liner to cover the raw bumpy inner sides....
Looking at the rear step of this 100 mph Skater answers my questions.
[IMG]
[ATTACH]
I believe the pics I posted are the best I have in the water to show this but the transom is 27" tall, the cavitation plate is 1.5" above the...
I am in Mexico. I would think that euro transoms shorten the running drag surface & help bow lift, so there must be a reason that most of the...
I have a pilothouse catamaran is running 50 mph with twin 225 outboards with 25" shafts. The motor is all the ways down, and because she is light,...
Thanks, very useful input. FYI, Amazon also sells PVC gate vales for around $7. Great Quality. My hull is self bailing, so the only water I...
Thanks for your comments. After taking a closer look at this, It looks like this is not as feasible as I had hoped if I want to use standard...
32" wide is what the Seacat 22, Worldcat 23 and simular boats have here in USA and even with a flat bottom rear to provide more floatatiion, still...
Looking for reference material or suggestions to help me design a sealed deck over bulkheads in a 28 x 9'6" FRP power cat. Have incorporated 2...
You may be right about maintaining the higher planning speed. In the 3 2hr break in motor tests I ran, I had to cover a lot of other questions,...
Other smaller cats I have owned all started to plane at 12-14 mph and they were 30% slower at wot., So our experience is different.
I have twin 225 hp 4 stroke Mercs on her. Boat rides too low in the water at 25. needs a lot of speed to stay on top and find her sweet spot....
You seem to be focusing on tunnel slap and that is not a problem. But you again confirming the rocker is not needed makes perfect sense to me as...