I have a V drive boat that is 32% downdriven. I'm putting in a new motor (that only revs to 4000) with almost double the power of the old. I would...
As a midmount it was direct drive 1:1, as a Vdrive 1.32:1 and at WOT the prop will only turns to 2400 for both set ups. To reach 4600 from 3200,...
-Pride starfire runabout, low sides. Ski boat style. -3.3L Holden straight six (about 100HP). -not sure on weight. Fiberglass, wood frame, full...
I converted my mid mount 6 cylinder, 14 foot ski boat (which was originally outboard), to a rear mount V drive using a suzuki jimny transfer case....
Im going to move the motor fully aft and use a 4 by 4 transfer case as a V drive. But because standard transfer cases are not high ratio, i was...
The cav plates i put on covered the whole transom, extended out 30 cm and fixed a 12 degrees up, didn't seem to have effect. Same revs, same...
I own a 15 foot fiberglass runabout that i converted from outboard to mid mount inboard with a holden 6. It took me about 9 months to complete...
It revs to 4000 easy with no load. I had a friend watch the way the boat rides from outside the boat and it doesn't get up on a plane properly, it...
I have read that a traditional pitot speedo cannot give a speed reading HIGHER than actual, but only LOWER. The prop is brand new, and i had the...
It gets up on a plane easily and fast. Probably 2 seconds from idle. It revs up fast enough but just cuts at 2400.
I am allready getting 30 mph at 2400rpm. Does that mean i should get about 50 mph at 4000 rpm? The motor is quite far foward but it feels like it...
I converted a 15ft fiberglass outboard runabout to mid mount inboard using a 202ci 6 cylinder holden (GM) motor with the prop shaft connected to...