hi there, i have a 10meter motorboat, with a perkins 4236 75 hp that i intend to fit in it. i plan to fit a python drive, but not sure what mounts...
hi there, i need to replace the gunnels on a 34 ft grp motorboat. They are currently oak, but rotten. Whats the best wood to replace them with,...
hi there, i need to replace the gunnels on a 34 ft motorboat. They are currently oak, but rotten. Whats the best wood to replace them with, oak?,...
hi there, i have replaced longitudinal stringers in my boat and this time glassed them in ( over 3/4 inch marine ply) . Originaly engine sat...
hi there, i need to get hold of, or make a large boat hatch big enough for my 175 horse inboard to fit through. I have extended the cabin, and now...
Need a flat day for this one. What a simple design![ATTACH]
Hi the1much, thanks for your advice, didnt really want to rip it all out but gotta do it properly! You gotta a great `writing accent`! Texan i...
Was working on structual bulkheads on a 34ft motorboat whilst it was in tidal waters and was advised by all you people to get it out of the water,...
Thanks for all advice, boat is coming out of the water! Putting it on a trailer then blocking it up, guess this is better...
Breaking News Have decided now, thanks to you all to take the boat out of the water! Will be putting it on a trailer and then support it by...
Thanks everyone for depressing me! Well thanks for your advice, thats what i wanted. Have been doing it as i have as have been told by different...
thanks, have included a picture for you to see, have replaced the starboard side already, doing port side now. Have replaced smaller port sections...
thanks for reply. there are two longitudinal bulkheads either side of where engine will go, with small bulkheads each side, a two foot gap is...
Hi there, am working on a 34ft nelson( motor boat) thats in tidal waters. Am replacing all bulkheads including longitudinal ones. Are they best...
Thanks Teddy, well have already started laying over ply, have done three layers already, was planning on taking the ply out afterwards, do not...
Thanks for replies,will try to post a photo to show what i mean, there originally was a 120 hp engine in, when purchased boat came with this...
Its was originally done in grp, is there such a weight issue? Thanks for reply
Hi there, i,m extending the cabin on my 34ft motorboat, how many layers of 450g csm should i use, need to walk on the top on it after! Cheers
Hi there, i have a Perkins 6354-t, 180hp, want to fit it in a Nelson34, the engine bed is attatched to marine ply 3/4 inch, am not sure if this is...