Search Results

Search Again
  1. shipdesigner
    Post

    Coupling

    Modified the coupling again and the locking nut will have the ff: - 74mm outer dia - 80mm deep - 1-3/4" thread at 8 TPI - 4 off 7mm dia hole...
    Post by: shipdesigner, Feb 27, 2008 in forum: Boat Design
  2. shipdesigner
    Post

    Coupling

    Maximum torque is 3,000 N.m.
    Post by: shipdesigner, Feb 26, 2008 in forum: Boat Design
  3. shipdesigner
    Post

    Coupling

    Thanks to all who responded. It was very useful. I have modified the design and I come up with the coupling design below. There are four (4)...
    Post by: shipdesigner, Feb 25, 2008 in forum: Boat Design
  4. shipdesigner
    Thread

    rudder table construction

    can someone pls give me an idea how to check the strength of rudder table? which load or force should i consider and is there any formula, related...
    Thread by: shipdesigner, Feb 25, 2008, 0 replies, in forum: Boat Design
  5. shipdesigner
    Post

    Coupling

    CDK, thanks. Frosty, thanks. That word SAE means so much to me.
    Post by: shipdesigner, Feb 22, 2008 in forum: Boat Design
  6. shipdesigner
    Post

    Coupling

    thanks. but this site has no specific calc for the said coupling.
    Post by: shipdesigner, Feb 21, 2008 in forum: Boat Design
  7. shipdesigner
    Thread

    Coupling

    I'm designing the coupling for a 63.5mm diameter propeller shaft but I don't know how to check if it's strong enough to hold the shaft. Any...
    Thread by: shipdesigner, Feb 20, 2008, 20 replies, in forum: Boat Design
Showing results 1 to 7 of 7
Search Again