Hello folks, I have found that many boat builders or enthusiasts have solutions specific to their particular build that may be of interest to...
Anyone out there have any experience on the wiring of high current loads Like drive trim and trim tab motors? What initiates power to the? The...
Hello all, I have a project boat I have been working on for 2 years and I have come to the point where I have to install batteries. I have...
I have a 36 foot with diesel and surface drives. I have two options, a 12x 24 or 12x18 with a taper where as the end is only 10" wide. Is it...
I am running two diesels; 6LY2. I am using a VSR so I have dedicated cranking batteries. I chose the optima red top that had 1000 Cranking amps...
I have had many opinions on this point. I have an intrepid 339with twin yanmar 6LY2 and surface drives. I am using transom scoops for engine...
I am trying to determine best method for painting cast aluminum drives below the waterline. I have a cast aluminum surface drive that I have...
I have reworked several boats and it has been a chore to find specific products. Can anyone help with the following" 1/4" MARINE GRADE...
Hi Folks, I have a modified Intrepid 337 in which the outboard engine bracket was removed and retrofitted with Yanmar 6LY2's 440BHP. The...
________________________________________ I would like to install a forward looking sonar head into my 339 WA. The head is large and must be below...
Hello all, I have a 339 Intrepid WA with a small Cuddy. I am in an area where 220V is prevalent. But will bring the boat back to the US...
I currently have a c120 with the low profile airmar head. Unfortunately according to airmar, this head is diplexing and ALWAYS sends 50 and 200...
I have finished installing new ZF two speed splitters on my ZF 110 ATS marine gear. From what I understand, when these splitter fail, the failure...
Hello Folks and happy New Year. I have had the pleasure of falling into working on three separate boats. All powerboats over 30'. One of the...
Just a quickie.....input appreciated. I am re-plumbing a fiberglass hull using flanged seacocks with Silicon Bronze thru bolts. This works...
Hey Folks. I have been boating for years but have not had much opportunity over the last 5 years as I have been stationed in Kuwait as a US...
I just bought this boat and I am trying to figure out the manufacturer of the Surface Drives. The boat itself is a 1997 Intrepid 337 Walk Around...