Hi CDK Yes, dometic and I usually run it on gas but had thought to use 220v while the boat is moored so we had a cold fridge ready when we arrive...
The final decision . . . . ? As always; thanks for all the input - even though I understand almost nothing of it! :) What I've ended up going...
Many thanks Bert!
So from the above I take it my panel can be expected to degrade over time, yes? If so, that doesn't bother me too much as it would be several...
Confused! Thanks Bert but now I'm confused as I thought the purpose of a solar controller was to regulate the charge to prevent continuous...
Thanks again everyone. I will update once I have it set up. Cheers!
I have found a simple low cost solution on Aliexpress.com in the form of an EP Solar 10A duo battery controller for <$30. It seems you nominate...
Wow! Thanks Bert - that's awesome
Many thanks. I've decided to go this route for the engine batteries and will forego the fridge idea which was never really a priority. Cheers!
Thanks Chuck, it does help. My system has a single 12V 630CCA start battery charged by a 75A alternator. The 120AH house battery is then charged...
Hi all, Firstly; what I know about electrics can be written on a postage stamp so please bear with me . . . . I went to check on our boat (a 3hr...
Many thanks - will do that in future. Filler is only about 1 - 2mm thick so shouldn't be an issue. Cheers!
Is there any issue with laying new glass/epoxy onto uncured epoxy filler (in this case Epifill) or glue? I'm modifying a hardtop and waiting for...
Has anyone any experience with this system employing a traditional manual toilet please? I am replacing my holding tank with the EST12 unit but...
So, to close this out: Relaunched yesterday after stripping and rebuilding the port driveline. Straightened and welded a small crack on the strut...
So; another quick update . . . . Lifted the boat out and had her all cleaned underneath and then found two things of significance: 1. The port...
Hi WestVanHan - All cylinders checked at the same spot under load but only one engine as access to the stbd motor is very poor without removing...
Thanks again guys - just back from a night away and I now have dark exhaust water and much steam in the exhaust flow. Cylinders appear to be...
Well, I'm out of ideas! We have checked, cleaned and adjusted everything short of removing the front to check the cam timing but since that is...
Thanks Redtick. Have bypassed the filters/primer and associated check (non-return) valves but will try blowing back through the return line....