thanks yall, and sorry for bringing back an abandoned thread.. i dunno why i didnt respond.. id want a lower revers gear for power, lower rpms...
erich, i just tried to join the refuge forum and it wouldnt let me use a yahoo or hotmail email, those are the only two emails i have access to....
HAHA im in a very tough spot. i prbably will and up not doin anythin like this. i built a longtail a couple years ago and ran into the added...
sorry, didnt see these last two posts. youre saying i wouldnt need to worry about sand or little bits of mud goin through the motor? of course...
gonzo, i meant JUST relocating the water inlet and bypassing the pump with electrical pump. no radiator. i dont even know that the advantages...
i could make it where cold water routes through the motor and everythin the same right? im thinking of just relocating the cold water inlet and...
the briggs n startton aircooleds are just such small hp that it wouldnt even push my boat out of its own way. CDK, i like this fitting. Do i...
frosty: its all about money for me. i would love to build my own surface drive but im in way too bad of a bind to do all that. the boat i got...
your saying to cut a small hole, or more, on the front of the boat for an inlet? Hhhmmm..... id just be worried then about stumps and randon junk...
*of course im saying this planning on a free or grealty dicounted radiator, otherwise i would just buy a longtail
im not too too knowledgable on every aspect of an outboard motor, but i got to thinking earlier (thats where i went wrong). an air-cooled mud...
im designing a boat(just in very early design stage) powered by twin vanguard 35's. i need to find a transmission that has only a...
nevermind. i got it. yellowfin or yellowtail is what i was lookin for, the ones that do all that to the RIB's.
im lookin online for a boat i remember seeing online a couple years or so ago. it was a dual prop type surface drive but they built it where you...
illegal?? i've never heard that before.... thats how all the longtails and surface drive are done here in the south, actually all over the U .S....
the shaft is coming out the transom, right? i see a lotta mudboats with the shaft comin out the bottom, not a true SD. i dont see the point in...
i think it may depend on your application. i've never seen much of a point in fixed drives and a big rudder. but i also have never had a boat...
oh mcmaster carr has you covered with bearings, seals, etc... great company
look in the surface drive section. theres a guy that built a longtail with gears, you could substitute the gears for your CVT. you have a very...
does anyone know of any reading material that goes into detail about how belt drives work? different types and how different types are powered?...