Sounds like you bought the same probles as I did, firend! This is how I approached my rotten mess... If it is rotten, remove it. As I...
Yes you can. The first thing to do is use 800 wet dry sand paper on a sanding block. I like to add a dab of dishwashing liquid to a pail of...
I have finished the interior and exterior of my rolled edge bayboat and need to install my new drain tubes. Seems one can't walk into a marine...
I just finished my floor job and noticed that the old plywood floor was AC rather that marine ply. I went with BCX and glassed both sides...
I've found it at West Marine and plan to own some today! Thanks for your help, Howard. Chris
Alright then, NAPA it is. Is the 545 a NAPA product too? I'm ready to get all those boat parts out of my garage and on the water! Thanks,...
I'll look into AWlgrip 545, Howard. I guess this is some sort of primer? I'm pretty new to the boat and glass thing and need to do my research....
I'm closing in on the final stages of my rolled edge bayboat restoration and I could use some input. My hull is a 87 bayhawk and the gelcoat is...
Well as usual, I think its too late for your approach now. I have completed the floors and decks and everything is glassed in, cabosiled radiused...
Good point about expansion/contraction. I've been noticing the recommendation of 3M 5200 as an outstanding product. I'll have to get some and...
I'm new to this board because I have just purchased a 18' Bayhawk center console with rotted floors. I knew this going in by the way. I have...
Nida-Core I'll have some info for you in a week or two because I'm doing the same project. 18' Bayhawk with rotted decks. I have a friend who...