Hello Par thank you for that tip.. I would've never known. It happens that there wouldn't be that much waste by looking at your diagram. We are...
I've only talked to Katie over the phone so far. I shared some information on Okoume and maranti plywood that I found on a website...
Alan thank you once again for all of the expertise you are providing. jan
Thank you Alan for the Hamilton Marine connection.. We went there Monday... Great prices and selection. Janet
Thank you Par... I persisted on the Maranti BS1080 and as it stands they can only get 1/2 " and 3/8" Maranti so we'll end up using 2 of the 1/2...
Has anyone heard of Lauan marine plywood?? My supplier is having delays getting Okoume or Maranti.
Ok Now I get it ... But I was only going to epoxy and allow the surface to be washable.. I thought putting carpet on would just hold onto moisture...
Under the rubber nose of the prop is a shear pin if thats broken it wont turn. Just another possibility... its happened to us. jan
Did you try sanding off the magnets under the flywheel?
When using epoxy do you still use the woven cloth material as a basis like you do with fiberglass? Jan
Thank you Alan Your advice is highly appreciated. It turns out I also have to replace the deck and seats in the bow as well as part of the floor...
I found a plywood supplier with reasonable prices in No. Yarmouth, ME "Fat Andy's" Im not sure if this would be helpfull. Jan
Hello Im new to this site. I recently bought a used 16' Mirrocraft boat with a 75 hp suzuki motor... We took it out and after a few times out the...
