http://www.discountmarinesupplies.com/Boat_Cleats-SEACHOICE_STAINLESS_PULL_UP_CLEATS.html...
If it doesn't have spark, check your shift cut out switch. If you don't know what that is, bring this site up:...
I loved my jet with the 460 Ford & Berkley. It was a major hoot throwing it into reverse at 40-50 mph and come to a sreeching halt, water shooting...
You may have to use a wheel puller to get the prop off. Once off, if the boat was designed correctly, the shaft should just clear the rudder when...
And toward your other point there is definitely a lot more labor in the vacuum bagged cold molded mahogany and teak decks than ever would be...
The beauty of the tunnel is in the simplicity and weight distribution that is possible by not hanging 1500 pounds of motor and drive on the...
...high side...good for the consumer as it is often what the banks use...
These values are usually on the hign side:...
Rot info: http://www.rotdoctor.com/
Post some pics if you can.
or is it underneath..?
Whether your CB25 is your only boat, or one of many, it's an investment for which your family will thank you, now and for decades to come. With...
Here's a start: http://en.wikipedia.org/wiki/Hydrofoil http://web.mit.edu/2.972/www/reports/hydrofoil/hydrofoil.html http://www.foils.org/
To be more exact, it is Spar Urethane, not varnish.
I would use a paint and varnish remover, then sand smooth. Not sure about the house stuff taking a topping of marine varnish though. An oil base...
Try joining this Forum, if you haven't already: http://www.justjetboats.com/
check here: http://www.southwindjetboats.com/index.html http://www.justjetboats.com/forum/index.php
Can a dinged up prop cause a loss in engine RPM, at WOT there by causing a loss of speed? Not that much if any. I would check the accuracy...
Check this out: http://en.wikipedia.org/wiki/Jetboat
The engine is most likely cooled by water from the main pump through a small hose. It is not a good idea to impair this water flow. If you...
