Holy thread from the dead. Anyway, I swapped over intake manifold, mechanical fuel pump (had to buy a pump pushrod because the guy removed...
You said the switch interrupts when the drive is engaged into gear. I'm TELLING that it is in fact NOT. It is used to get the drive OUT of gear...
This is incorrect information. The microswitch is there to to "blip" the ingition on the engine in order to get slack in the dogs so that the...
for future reference, they usually seize on there. Just take a chisel or a screwdriver and put it on top of it and give it a wack or two with a...
check my replies in this thread: http://www.boatdesign.net/forum/showthread.php?t=17594
for what it's worth. Previous owner of my boat (26 foot nova II spyder, T454) put an aftermarket fuel injection system on it (made by...
Sounds like oil is leaking into the exhaust galley. It's most likely either the seal in the upper unit taht fits around the vertical driveshaft...
sometimes on the 3.0 liters people get lucky like i said and only crack the outer part of the block (under the intake/exhaust manafold is a good...
Unless you plan on putting in a closed cooling system, your nice aluminum motor will corrode away before you know it. You also need to install a...
Your carbs could also be dirty and all gunked up. If you get a bunch of acetone or laquor thinner it'll eat right thru that varnish. You can...
good luck. Sometimes those 4bangers just crack externally or blow out a casting plug (improperly called freeze plug). I wouldn't rule out a...