The main engine is a sealed diesel toyota unit very basic and reliable ,air intake and exhaust are both above the waterline the engine itself will...
Hi, my car has a chassis/frame of 100mm x 50mm x 3mm RHS and is skinned over with 16SWG (1.5mm) steel sheet. All hollow section or dead air space...
the diff is inside an axel and mounted on releativly small points (bearings) the only way it is going to be cooled is by heat transferance through...
Swivel joints on my landie are double lipped oilseals with a spring tensioner and all the swivel surfaces were checked,I have spoken to people who...
axel tubes As I mentioned before I am using outboard legs ,these will be bolted through the side of the 8" tubes using the cavitation plate as a...
Hi sorry for the delay ihave been busy with work. I am building a Searoader using guidelines purchased from Mike Ryan at Searoader.com .There are...
Hi i was just looking around for info and noticed "Axelbrit" is building the same car as me ,I would be interested to know how it is going and...
