Hi Daniel can't help with waterflow specs or high torque shaft dimensions , it was a long time ago. I suggest you contact Naiad Dynamics in...
Without a photo it's impossible to tell ,which spares do you think you need ?
At one point a forum member had the moulds for the Hunt 18 ,I think his name is Gary Bull ,try a search.
Hi baeckmo ,hope you are well. You are right it's a copy of a pp, the impeller should be measured at the inlet.
Some photos of the impeller and the wear ring and nozzle would help,
See above for dimensions ,and no sorry no pictures of inlet.
This is the same jet, but the "inboard" version ,showing more detail of the impeller ,wear ring ,and nozzle
This jet is powered by a 2litre turbo diesel engine the mixed flow impeller is 270mm diameter and the nozzle diameter is 150mm[ATTACH] [ATTACH]
Good morning Duco,there isn't a link that will solve all your problems ,The best advice that I can give you for what it's worth is to type...
Well you can source these details from manufacturers brochures. Hamilton jet's website will give you all that information ,that's the easy part,...
Hi Duco you haven't made it clear how much of this project you have inherited ,and how much you have made . Is this a failed experiment by someone...
Sorry it's sold.
Hi Philip got your message thanks ,I have checked both sleeves ,and no clever trix I am afraid .Your injection system is not completely electronic...
Standard gelcoat will cure with a tacky receptive surface, ready for laminating. If you add wax to it, this forms a film on the surface and...
I am using an android tablet bluetoothed to an obd reader , the software is torque pro downloaded from the play store very inexpensive and has...
Many thanks for that Magnus
Hi baekmo. Marinising this engine was a bit of a learning curve back in 2016 I asked for some advice on here as I knew very little about...
Thankyou Eric for your input , I will look out for developments in this technology,with interest, however I tend to be a bit conservative in these...
Thanks baeckmo I intend to go the larger intercooler route.