rasorinc, I may be a little late on this but your Oregon location caught my eye When you say shallow water running how shallow, I use to be in the...
valvebounce, by the serial number its a 1999 but one year is going to matter just starting to work on boats again after a five year break but I...
check the charging system to much voltage can cook the coil
the color of the motor says out of the 80's but merc uses serial numbers for all part look up. but by the model it was only manufactored from...
cng is an option for boats but my questions are 1- wieght of cylinder for cng and 2- does cng fall in the same regulations as propane gas
unless you're willing to add wieght to boat the sportjet package is about the best you can do the other option would be an outboard jet and that's...
if it is nav and anchor light on one toggle switch that is easy you need a three pos. switch (one-off-on) with six poles on it or to say it...
most of the jets i work on in the northern half of california are good for 3-4 inches of water with the boat on plain over rock and sand but with...
? is this a 120 merc sport jet (that's what i'm assuming) so are you saying engine is cutting out or stumbling bhofm sound to be on the right...
parts washer take a moment to look at the ihba web site mclellan did set the ets posted by ellison in augusta. his claims are backed by ihba so...
if you up grade to electronic ignition and left the old coil in the system then yes you need the resistor to the coil or you need to replace the...
ben2go, about the lake that banned 2 stroke, what lake and what technology of two strokes were banned, for some two strokes are cleaner than a...
at what rpm is that motor trolling should be around 800rpm if this is to fast and you are just looking to slow down how about a trolling plate
Some Of The Engines Also Have An Overheat Sensor, So Also Disconnect That To And See If The Engine Runs Better If So Replace The Sensor If Not The...
threeofme sorry its takin so long to find it but 35530L is a 1962 40hp got lucky talking to another shop and someone had one of the archive manuals
grady, i myself don't want to ruffle feathers. my statement comes more from feeling over regulated by government and laws. i'm in california so...
olbob, start simple one thing at a time lazeyjack gives good advise most of the time just have to get over the rough edges of language differances...
use to run one of those with a little porting done ran for years with a lot of abuse if i remember it had a larger stator and higher amp...
you have a pretty big range of years for that lower unit
but if it is a three cylinder 60hp evinrude go for it i've used a ton of these engine in the califonia delta on houseboats from 28ft to 56ft...