I have come by a 115 HP V4 Mercury power head and jet drive. I cannot find an identification plate on the motor. However, There is a flat spot...
Here is antoher site you might find interesting. http://www.rjet.com.br/funcionamento.html These guys are located near me. They have attached...
I am working on a similar project using a newly designed hull. It seems to me that if the Toyota can run all day long at 3,500 rpms and we put...
If I understand your original statement you wanted to build a plug and then a female mold so you could have a gel coat finish???? Build your boat...
I found the site that stated thin PVA was a no no. http://winshipmodels.tripod.com/pva_mold_release.htm
I am not sure if 1 mm is too thick? However, I did read an article put out by a supplier of PVA that a thin layer is much worse than no PVA. They...
Thank you for the response. That makes sense to me. Not the first time I had used PVA. Just the first time on a mold that had a design that had a...
I built a form and made several 15 gallon ice boxes. I pulled the fiberglass boxes off the waxed form with little trouble. After applying 10 coats...
The boat pictures you posted are pretty straight forward. A steel hull with a wooden cabin slapped on the top. Don't know how thick the hull plate...
Some food for thought .................. I looks like you used a flywheel for a front wheel drive. When this motor is hooked to a conventions...
I installed a new 1.9 non turbo in a boat a while back. I did the gear box thing a little different from you. For what it is worth, I cut down an...
Here is a cat that looks like it is going fairly fast in the video. http://www.amiboats.com/Sport%20Cat%20AMI%20Boats.html They sell one under...