Those Prisma preformed stringers look pretty good to me. I couldn't say if they are a good stringer for an inboard application that would be using...
I noticed it didn't have the same luster as the parts I've made with Meguires. But in this case, this part is getting painted with Imron along...
I finally got around to finishing the recessed instrument pod for the console today. I had built the mold last winter and its been sitting in the...
I haven't yet made the part. I have been inundated with work and honey-do's at the house. I have the mold sitting on my work bench. It needs a...
A 4x8 of 16mm NIDA (~5/8" thick) runs about $55 from FGCI. http://www.fgci.com The big hit is in the shipping. Its best to find someone local to...
You don't really need the Bluewater 26 Coosa for a deck. Their 15 lb density board is just fine. I re-cored a 11' x 4' hatch in my deck with 1/2"...
I'm always looking for something new and interesting to read.
Good surface prep is key. Rough grind the old fiberglass that you are bonding to and clean it well with acetone. I'm not sure what part of the box...
Epoxy is compatable to cured polyester. You will have to rough up the surfaces of the existing polyester laminates for the epoxy to get a good...
You might consider clear coating with a paint like Awlgrip or Imron.
This is a mold I built last weekend for a recessed fiberglass instrument panel. It is 1/2" MDF plywood. All the corners have been rounded. I will...