Thanks for reply , i made several times the multistep infusion with vynilester but never with epoxy that is very choosy for the joint for...
Hi Guys , i have to build a 10 m boat (fibercarbon sandwich ) using infusion method. I would like to know if is possible to perform in 2 step ....
Hi Guys , I have a small pushboat with a Displacement full load 350 Kg so my question is there the possibility to push a barge with a similar...
Thanks for the precious support so we can keep the scantling of post 19 ( that is perfect regarding CG calculation and freeboard ) and the...
Sorry for delay.. http://imgur.com/a/yXxPw http://imgur.com/a/9JUow http://imgur.com/a/C1SHL 8800 mm. Loa 2900 mm. Beam 2x250 Hp Outboards XL...
An Out of argument question what do you think about the thickness of 5 mm for the bottom and 3-5 mm for deck ? It is accordant with ISO 12215-5...
I hope that was misunderstanding....thank you so much for your precious support and clarification.
Hi Guys , what about the weight of welds for a 8.8 meters aluminium center console using MIG ?How can it be estimate ? The aluminium is 5083 . I...
Hi Guys , what documents and certifications needs a boat that will be imported to Australia ? The boat is 8.8 meters .There are also restrictions...
Thank you Barry for you clarification and precious support. Regarding an aluminium planing hull like the following pic...
Hi Guys , i have seen several system to protect the Aluminium Hull in the last years like the use of magnesium , zinc anodes or only coated but...
Hi TANSL thank you so much for reply and for your precious tips have you got some reference plan? What do you think about the use of 225 g/m2 for...
Hi Guys ! I am studying about lamination schedule for a motor boat of 19 ft . Have you got some example as reference ? What is the right value...
Thank you so much for reply. What about the interference during the planing? Could be a benefit ?
I have seen a motor boat of 20 ft with a thick swim platform . What are the benefits of this solution ? Could cause problems during the planing...
I will suggest you to have a high value of deadrise over 20 degrees to have more dynamic stability in rough wave condition . I know that increase...
The stern and rudder is like this one on the right I need a company that supplies rudder stocks [IMG]
Hi PAR , the boat is a simple canalboat with a symmetrical divergent airfoil (fish tail ) section for the rudder.The material of the boat is...
Hi Guys , could anyone suggest to me a company or a tips for a rudder stock for a supported on keel ? I have doubts about the bottom bearing....
Thank you for reply , the hull had generally two inboard engines but the proposal is to install two IPS system .My doubt is also regarding the no...