Here is supposedly the most current Tesla of our time. Using the ignition energy to split the H2O. http://www.youtube.com/watch?v=D7BAODqqcpQ...
Well put, I understand and agree with your optimism. Everything must be repeatable or it's theory. I run into info such as this....
mydauphin, Attention!!! Attention!!! Call Bob Lazar, Someone stole the alien space ship. Can you pass me the dilithium crystals....
Darwin deduced we evolved from the ocean because the salt content matched that in a mothers womb. This might require even less expossure to treat...
This was sent to me by a friend and I thought it would interest some of you. Not needing a fuel tank or being concerned of fuel at all. Let's hope...
I've looked at some different tank configurations and don't care for lack of access. If the tank needed any kind of service it would be a pain....
Matt, I was waiting for someone to shoot the tank under the sole down. Thanks I wasn't married to the idea. I will be using the epoxy for...
Thanks PAR I will do all you say, and yes without a shop this is quite a challenge. Add reinforcement to the inner face of the transom and...
Thanks for the replies, When I first found the soft sole I took my boat by a couple of boat repair shops. I firmly believe I would be doing this...
Hello Boatguy That was my original idea with the aramid, but even the carbon? I thought two layers of the low grade carbon...
Marshmat Thanks for the comment and the reply. These pics might help show the 22oz layup. I learned alot on that section, If you...
I consider the two are like cheese and chalk. One stretches a mile, the other is very stiff. They both have good tension quality, the kevlar has...
These pics show the 22oz triaxial layed along the sides after grinding all of the PER and old glass out. Again Any suggestion are appreciated....
Hello All, I'm at a turning point in my project. I was going to use this advanced material for cosmetic but I'm having second...
I'm not dead set on filler glass to glass is fine. Thanks JR
Thanks, I was thinking of adding some graphite filler to my precoat to help the bond to the old(1991) glass? Is this logical? Here's a pic of...
Hello All, I'm getting ready to epoxy plain carbon on the inside of my transom (x2 layers). 1st layer/ Warp bundle across 2nd layer/...