Whats going on chuck this is van Im running a glass shop too in lavergne give me a holler sometime.
My Experience With Cracks In Gelcoat Is If The Repair Was Done With Epoxy Some Times It Will Be Too Rigid,fiber Glass Has To Have Flexible...
polyestersounds right
duratec clear is good but if you are not an experienced painter you will be sanding alot of runs or sags. and partall film #10 {P.V.A. poly vinyl...
as long as you dont put any additives in the first coat. You dont have to sand it you can wait about 30 min. and spray again with the top coat...
there is a material that is used for screw retention its called trevera core. It is wet out heavily with resin then applied to the inside of the...
2% is the correct amount to a 2 qt. pot add about 40 cc's. about the same as mekp. too much takes along time to evaporate and will leave it...
I like the duratec surface primer w\ clear additive mix about 2 to 1@2% mekp thats 2 parts primer to 1 part clear.in about 4 hours you should be...
the most simple answer for you i believe is pop rivets they lasted awhile already Just rember nothing last for ever anyway. but seriously Ive...
if you want your gelcoat to match you need to go to the customer service manager for the manufacturer of the craft.you need:the serial# of the...
Are You Spraying A Master Or Mold ? On A Master Ihve Used A Duratec Surface Primer W/ A Clear Additive That Will Make The Surface Primer Tac Free...
WHEN YOU SPRAY GEL ON A PART YOU CAN THIN WITH STYRENE ON FIRST COAT AT ABOUT 5 TO 8 ML. DO NOT PILE ON! YOU WILL HAVE PEROSITY {ENTRAPT AIR} IN...
