1987 Luhrs Alura 35, down east style, 3/4 keel, twin f.i. Crusader 454, model 350. 1.9:1 Vevets, right now turning 18x18 3 blades nib. 4300 rpm...
can I use polyester filler to fair between coats of west epoxy? I was kinda sloppy while doing a transom repair and now have some pretty good...
Hello, looking for info on weight of crusaders 454 engines and Vevet drive trannys. Am considering an engine swap, but are concerned about the...
Hello, anybody have any experience w/ cutler fuel inj. kits? Am looking at a set of engines that have this setup. Any info appreciated. Mark
Hello. I am considering putting a transom door in my 35 Alura. The transom is made of 3/4 ply blocks, sandwiched between about 3/16 of fiberlass...
Hello all, another question to those in the know! I want to move my batteries forward. My two choices are mid cabin, under seats OR all the way...
Posted - Oct 15 2006 : 08:32:38 -------------------------------------------------------------------------------- I removed the...
Hello, again! I am in the process of replacing my transom due to rot below the waterline. While in the midst of all this mess, I was thinking...
My rudder stuffing boxes (twin screw) are mounted to the underside of the hull. Not set up into the hull, like most i've seen. So there is drag...
Hello, I found a really nice deal on a running pair of takeout Volvo TAMD41's (200 hp). I'm wondering if they would be enough to repower a 35...
is anyone familar with the hull construction of these (1987,88,89) I'm trying to figure out what was used for the coring in the hull. Thanks
Hello, I am trying to figure out if the hull of a 1987 luhrs Alura 35 is a 'cored' hull. This boat sank, and, I'm considering a restoration, and...
