Marine-tex http://www.marinetex.com/PRODUCT%20PAGE_files/All%20MarineTex%20Putty/marinetex%20prod%20info.htm
It is kind of fun sourcing everything you need. I got stuff from Washington, Texas, North Carolina, Maine, Georgia, Montana, Iowa, California and...
Your points are well taken and from reading your post again, I see you are referring to catman021 using poly resin and likely not epoxy and in...
I have to respectfully disagree. Coosa bluewater 26 is structural panel that is used in exactly the same way as plywood. "Thank you for your...
Here is a price list from fishery supply....
I used coosa composites bluewater 26. Pricey but 40% lighter than ply and will never rot.
I used a composite material from Coosa composites. Very expensive, but will never rot.
I also started with a bad floor and ended up replacing the transom, stringers and floor. Really check those stringers because it would be a shame...
When I get to painting my boat I do not want to just mask the rub rail. It is the type of construction where the Cap overlaps the hull and the rub...
Thanks for the reply I am using 45/-45 12oz 6" biax tape. I already decided to tab in another layer but dropping it about 1.5cm down from the...
Just finished bedding, filleting and glassing in my stringers. I have read in a few threads that when using 6" biaxial tape and epoxy I only need...
Good move. The transom needs to be one piece. Takes about the same total amount of work anyway.
You are replacing the whole transom, correct?
Pat yourself down with packing tape(cheaper than duct tape) after drying, after the cold shower.
I am having a little trouble figuring out the amount of materials I will need to complete my resto. It is an 18' deep V. I am using coosa...
I would post this under the sterndrive section, you may get a few opinions there. I am always one for more power But, 1. dont know 2. don't know...
Transom is good, replaced not long ago and checks out sound. I have the boat removed from the trailer up on blocks, very well supported. I took...
I live in Fernie B.C. I am very interested. Likely a supplier in Western Canada as well. If you could post pics and instructions here or give me...
I am interested in those "other" materials. but have not received a definitive answer as to which to use for stringers and floors for my 18...
VKRUE, thanks for the advise, and no offense taken. Since last posting here I definitely have discovered, NEVER to use treated wood of any kind. I...