I would like some input on which set up is best, I am thinking about purcasing a seadoo jet boat and have seen them both ways All comments...
It seems my spark control gizmo under the fly wheel altough its new as per last season dosent advance enough even when i pull up the fast idle...
My 1990 Sea Drive Runs Great New Powerhead And All Put Stainless Thermostats In During Rebuild And Of Course They Are Stuck On Start Up, Any...
looking for used 4cyl 140 hp 25" lower unit for omc sea drive, evinrude or johnson. rebuilt as last resort $$$
I have an evinrude 140hp 4cyl (1990) as I way underway engine sounded louder & louder ,sounded just like engine knock, when I slowed down and put...
I need some seniopr input on this one, I found a boat in storage made by Pennyann under military contract, never used or completed completly open...
anyone have any after market solutions to increase max by 2000
I have 1975 27 ft Silverton single screw vdrive set up with a 318cu v8 225 hp with a 2:1 reduction. At 3000 rpm I belive im turning 1500 prop...
directly where the two wires go into the VRO pickup tube housing, moving the wires starts and stops the alarm, with the housing off the tank and...
Just put new powerhead on 1989 omc seadrive (1.6 ltr 140 hp same as Johnson Evinrude) also put new control box and harness from box to transom,...
iF ANYONE HAS ANY PONTOON BOAT PLANS i COULD USE AS A BASIS FOR AN INEXPENSIVE SHALLOW DRAFT DAY BOAT iM ALL EARS, tHANKS LOVE THIS FORUM
I need (2) 3/4 thick 46"x72" sheets. Maybe 1/2 if it is bondable. replacing 2 bulk head walls, strength is important. must come up with...
What to use Replacing wooden bulk head on glass boat I have an older silverton glass hull, glass over wood upper, the bulkhead that seperates the...
I need some advice I had powerhead replaced by an outboard mechanic, carbs rebuilt ,new vro pump, new coils,plugs wires,power pack etc. heads leak...
Hey guys, need some advice I'm working on a 1988 aquasport, full glass in & out. Its in excellent condition but it has a couple of soft spots...
I have a 24 foot Baja and I am removing bracket,outboard and most of interior and floor. I also have a marine small block chevy aprox 260 hp , i...
is it possible to put a simple gearbox (forward neutral and reverse)between engine and jet drive and shift it into reverse at idle to suck water...
I purchased a 24ft 1984 baja speed boat with a 225 outboard, Steel gill bracket rusted out and interior is shot contemplting converting to v8...