New design will test at 30% scale as a 4ft rigger on 2.4kw 780kv out runner 22.2v 6S 5000mah cells. 3in prop.
I have a prop from Ron Hill a 6.5x11 cleaver 3 blade (very nice). I will be testing it with the rigger. I have a coupler now and have on order the...
Thank you Kristine, Its going tobe intresting to see what I can make happen. I have a guy milling me out couplers for the 12mm axles.
Yes understand and thank you for your advice. I plan on using a small prop for max speed at the loss of some low end out of the hole power. So...
Using the above info I could speculate using just one of the gold 7KW engines could provide up to the torque of a 35hp engine. I have two of these...
And another 400W In. Range: EX.: Ultralight 402 with integrated battery (28.8 V / 8 Ah), Fishing kayak 13.5ft, 58lbs Example of use Speed...
Found these specs on a known electric trolling motor systems. Here are the stats the highlight is 400watts IN and provides 200W OUT- produces...
Specifications: Input power in watts 400 Rated voltage in volts 28.8 Final voltage in volts 33.2 Propulsive power in watts 180...
Specifications: Input Power Watts: 1,000 Output Power: 480 Watts (Comparable to 3 HP gas outboard) Static Thrust: 68lbs. Battery Output: 400...
Well I have obtained two large 7kw brushless outrunners.. there 48v 145A motors. I have two 120A HV controllers made for 48v systems. I have...
Good question .. Im not sure at this point I can only speculate what a prop of this shape could do. When I get the chance to try one out I will be...
Here is a great example of the use of pan cake type motor frames that allow these sort of ironless stator cores you can produce with minimum...
Thank you for your support, and the bearing tip. I have been educating myself on the task at hand. And have enjoyed my findings, I would like to...
Correct 'Rick... I spent alot of time designing electric outriggers in my past and know in the smaller boat world the power to weight is extream...
In the long run I want a prop cutting water at 14k plus with me going along for the ride taking advantage of high rpm electric motors and light...
I figure start off with one motor and add another gang them up as the fever for more hp/watts kicks in. True on getting on plane. I would imagine...
70% vs up to 90% is lil tough to chew on but.. the electric motors can turn up more rpm then pistons. Outrunners typicaly produce 85% to 93%...
Yes just a single seater perhaps 9ft would be better, need keep it light. Here is a pic for scale of the size im going. I can rewind the motor...
Model: HXT80-100-B Wire Turns: 8 Resistance: 32ohm Idle Current: 2A ESC Required: 130A Input Voltage : max. 48V Kv : 130 rpm/V Weight:...
I have been doing some doodles and liked this design here is a redering of the basic look 4.5 x 8ft mono two seater side by side. 3.5ft wide bench...