Many thanks Quequen, I appreciate very much your help on this, specially the DXF you sent that I will use to propose a spade rudder blade shape....
Dear Quequen, Many thanks for your quick answer,... I did turn off the osnap mode in AutoCAD to try again, however the error message still the...
Dear Thread, I am trying to use the NACA Profile Generator for AutoCAD. I did all as your instructions. I modified the coordinaltes text file...
Hydromax Passenger Crowing To abcdfg,...Many thanks for your help, it is make a lot sense, actually students were thinking to do it in that way,...
Hydromax_Passenger Crowing. Ad Hoc, Many thanks for your quick reply, i am totally agreed with your suggestion. In fact, I discussed that with my...
1. I was trying to use Hydromax software at the University to demostrate to the students the passengers crowding effect on a small ferry boat. 2....
Andrew, Many thanks for your appreciated answer. Unfortunately I do not have direct access to Maxsurf and Hullspeed software but through a...
Dear Zeroname, Many thanks for your quick replay. Yes, your are right, actually I do have my cata defined at MS, and I can read it at HS...
The following question is refering to Hullspeed (HS). Can I use HS to get hull resistence for a catamaran ?. I was lookin at the HS Manual, but...
Hi Guys ¡¡¡ Recently I was asked to give an opinion on fishing vessel stern bulb as the PDF picture is showing. Can somebody help me giving me...
Stern Bulb Hi Guys ¡¡¡, Sorry for change the matter, but I am new in this forums and I don´t know the exact place to go into ask for help. If...
HSB Center of Gravity. To Ranchi Otto This percentage between 34% to 36% of LWL, is measured: 1.- At rest LWL (static) ? 2.- Measured from aft...
HSB Center of Gravity. TAD, Many thanks for you interesting additional support. I will use and try all your suggestions to see the best way to...
HSB C. of G. To TAD, Many thanks for your complete information and suggestions. Many thanks for the Excel file I will see and try all. mvd535
HSB C. of G. To Ranchi Otto, Many thanks for your clarification. mvd535
Type of Welding To MikeJohns, Question is not for a particular case but in general and for any kind of structural type of constructtion,...
HSB Center of Gravity. To Ranchi Otto and TAD, Please pay attention to the answers got it from both of you,TAD vs RO. It seems to me that...
To Ranchi Otto, Many thanks for your cooperation by giving me this information. I have one additional question. LGC expressed as % of the LWL...
Better welding type. Lazeyjack, Many thanks for your technical opinion. Its look like a very reasonable solution to prevent problems. Thanks...
At steel hull, IE 80 meters long, we can use intermittent type of welding to install stiffeners on a plate. For bulkhead stiffeners, like flat...