A Moh since you are talking about a passeger vessel. I have to ask is it intended for use as a commercil vessl? or a privrate Boat If its...
I agree with lewisboats, Eric and Guillermo on all points, if this vessel is a ex fishing boat under the USL code the stability characteristics...
Its all very interesting reading but all people should ask the question what does seaworthiness really mean? Most of the posts dealt with the...
Borg-warner theadrore rice blvd hwe bedford ma 02745 ph [508)9952616
velvet drive require particular ateintion to the stack hight if the clutch packs you can find rebuild info in mercruiser manuals did u change the...
from my expiriance it sounds like curclulation pump problem or your themostate may be installed back to front or in the wrong position, also a...
I will ask the question agian how do you as a designer identify any hazard that may arise from the production of your desgined product and do you...
By the size of the boat and the fact that your going cruising form Sydney probably to the reef or south pacific I feel Steel is a great option...
Thank you Mike for posting such a relevant thread to boat design can you or anyone give a list of relevant texts on the subject wether or not for...
Hafiz sounds like your looking for intrinsic Stability i would think about this Design your boat as it where full of water use a number of sealed...
It is great to See some discussion on this subject in Australia under our legal system the definitions of Hazard and Risk are as follows " A...
i must say I am very disappointed with the response to this thread is there no designer out there that even looks at the hazards that arise out of...
Yes, I agree Kjell with all you've said, but FMEA only deals with design failure and My concern as senior marine engineer/ occupational health and...
to much EGP will slow the hot gas passing over the Ex valve this allows the heat to transfer to the valves thus heating them A diesel engine is...
most manufactures will give designers the info u need. Decide on what engine brand u wont to use and contact them thay should send u a auto cad...
john u have 3 options injectors, pump timing or compression check em all in reverse order its most likely injector nozzle wear
lovely thay will do a great job we have fitted a number to a number of vessels you will not lose speed at all u should gain speed a little and the...
as a professional engineer here is what i would do measure the exhaust gas temperature and pressure both are vitally important to a diesel motor....
the purpose of this thread is to promote safety management in the design process so answer this if you can What is a Hazard and what is Risk...
I must say this please go back to the original question what do we as designers do to identfy any hazard that may arise from or designs?