Hello I am looking for an alternative to the rotten ply in my bucket seat backs. This panel offers some strength but is supported by the...
I have an external polyester repair to do. Then I intend to flocoat/topcoat in white. My concern is a simple one. How do I achieve a good...
I have only really ever played with epoxy. I have a small diy VE job, where I want to sheath a tank and strengthen a couple of areas of damage....
Has anyone had any experience with these. My tanks fill, and breather are currently bronze or brass fittings going into tank and they are...
[ATTACH] [ATTACH] Going to template for a windscreen/deflector. Unfortunately a big flat screen will ruin the aesthetics but the wind speed...
Have the resin bound driveways hit the market nearby. Apparently they are permeable, with no weed issue. They stick small shingle stones in a...
I have a 7 wire Lowrance depth gauge. The wires are Red Black Orange Yellow Blue + 2 shields If possible I would like to connect it...
I have been plagued by a grp tank issue for a while. I replaced gaskets and hoses but still get water in my grp in built tank. Layup is a...
Hoping someone whom understands polymers and all that stuff can help. I have used this sealant in the home with massive success, and now I...
About to mount some offshore style bucket seats to the boat. Originally the bases were mounted using multiple self tappers. My initial thought...
I have a powerboat with a built in vinyl ester fuel tank. The boat has been laid up during repairs. Today I fired it up after filling some...
I have had some stainless seat bases made. I intend to paint them. There are a few defects on them, so I was wondering if an epoxy blend will...
I use 3m k15 glass bubbles mixed 40/60 with cabosil to create an easy sand mixture. I tried to snap and crush some of my left over mix in west...
Anyone had any success at thickening epoxy enough to act a bit like polyester topcoat, as I haven't had much luck. With silica it's either too...
I have re gelled the outside of a boat seat base. The first coat worked perfectly and went rock solid. I then sanded it down and did another 2...
My boat has twin step hull. The most forward step creates a low pointin the hull forward. If my water ballast (furthest forward and slightly...
Thought id update my own thread. Finally got all the ply off, and down to the solid glass in most areas, having trouble getting some of the...
I am planning new deck arrangement for my boat, and wondered if there is a way to work out how much speed will be lost by the extra weight of new...
Ive trolled the forums and im still none the wiser. Vinylester/derakane boat, epoxy repairs to outside spray rails and running surface..........
How much wetted area does a planning boat hull run on when at speed? Bit of an open ended question, but i have spent ages looking at youtube...