thanks guys, as soon as the rain gets out of here i will try it again. This time i will try laying it up in place and will use poly to help...
I need some help. I have done alot of reading, researching and watching videos. I am using west system epoxy. I removed my windlass in...
I never smelled the clutches burning. It is a pretty distinct smell, I would have remembered. As for the fluid, It still had a pink look but was...
My transmission works fine in reverse but in forward it is slipping. I have pulled the screen (it was very clean), pulled the valve (cleaned and...
I also noticed that the two engines have drastically different engine mount hieghts. about an inch different at the adjustment screws. rob
I took the shaft to a reputable machine shop. I am getting an aquamet 22 shaft cut to the proper length. I am contemplating pulling the...
I pulled the boat today: 1. I removed the flange, zinc, propeller and pulled the shaft. The key way at the transmission end showed signs of...
drew, The shaft broke right where it goes into the flange at the back ot the motor. The ocean was rough, but we were only doing about 6-7...
thank you for your replies. Note: I did not soak the carb overnite and blow out the passages. I will do this. I will check the float...
I have twin inboard 305's with rochester 4bbl carbs. The starbord engine runs great. It will run at about 800 rpm, warm. It will shift at...