Yes, but can an undertaking such as this be done in a piece-work manner ? And where do you start ? The underlying support deep in the bilge ?...
Where you been F14 ? The removal of decayed structure for replacement can take months(recall spending an entire fall season removing bronze...
The APA1-95 specification was revised to voluntary standard ps1-07 and later to ps1-09(in 2010). Otherwise, the panel listed above in the...
It's all good. It was this stuff. APA spec. Ps1-07, rev. Ps1-09. www.harborsales.net/tabid/130/Default.aspx?ProductTypeId=135 and using...
The long name is Medium Density Overlay. MDO. The type used for outdoor signage. There may be an interior version although I haven't come across...
Ok to put on some tunes first? [www.youtube.com/watch?v=ft82a4qZZ9E] MDO plywood is my new favorite. A couple of sheets were used to...
If my life depended on it I'd propose the hull had a foot or two of water in it and froze. Then envision a foot of wet snow over a couple of...
That spot in the picture of the keel at the forward blocking : looks as though the garboard plank has a hole and the keel at this location also...
Two more oil changes. And these relics take about 8.5qts each. After seeing how you turned that wreck of an OMC/Bayliner into a work of art,...
I'll start measuring, and thanks much.
Yes. The engine-room-mounted raw water intake strainers. Is there a recommended intake/outlet size or a chart with recommendations. The units...
I am looking for recommendations on the seawater intake strainer inlet/outlet size that should be used for my application. 1969 Chevy 327 engine,...
They seem to have wandered off ! Hmmm.
:idea: Greetings Mikovio, Hows it going? The decks on my project were covered with resin soaked canvas. More resin was applied at a...
Greetings, I've read your post a couple of times. Very interesting project. There are a few things I could suggest from doing it the wrong way....
And with this type of quality control I doubt there will be any schmoozing it up with JD Power this year either.
Same scenario as yours but mine was the intake manifold. We first figured the head gaskets or cracked block..but when removing the intake to get...
Usually the Mariner's Museum has the archived Chris Craft information. Not free though.
tranny acting up There are a few transmission re-builders around. Can you e-mail them a picture of the tranny ? Enjoy
for sale Here's one posted on another forum that's for sale