Yes, WOT only in the bay, idle speed in the tank. My tank is actually a big feed bucket and I have to remove the prop to get it in there. I...
While running close to WOT, the RPM increased and shortly afterwards (20 seconds) it overheated. The motor was jacked and trimmed up a little...
After warming the deck surface and heating the garage and applying gelcoat to the deck of my boat thinking I had the right combination for a good...
I think a mold and a liquid plastic that would stay clear. I heated some lexan once and formed it around the good lense for my old Plymouth. It...
I have good break points for working in sections and am rolling and brushing the gelcoat. How hot is too hot? The section that I did last week is...
I purchased 6 250W heat lamps and plan to do this job in 4 to 5 sections. I considered electric blankets but once the heat lamps are set you dont...
Thanks for the replies. I just put some more on last night and one area I applied very thin. As you said, today neither are hard like I think they...
It seems the gel is still wet since when I wipe it with acetone white sticky stuff comes off. Now after about a week it is a little better but...
It is in the 50's here in Houston. I heated my garage to about 65 and applied waxed gelcoat with a little extra catalyst to the hatches of my...
Why do you think the deck will be a problem? (it's Nidacore). I went with poly where I could mostly due to cost but I also want to gelcoat the...
Wow, I've mixed quite a bit of it and did not notice too much of an odor at all. I realize that does not mean it isn't there. I have heard that...
No, little odor at all and not offensive and I am pretty sure not explosive.
I used epoxy below the deck, up the sides and over the gunnels for structural repairs on my boat. I then used polyester resin on the top side...
It is poly resin. After three days now it is still has an ever so slight tack on the top. It is not structurally important enough to re-do so I...
The instruction sheet I picked up from my resin supplier says that "applying resin below 60* may cause resin not to thoroughly cure". I applied...
I am fairly new to epoxy use but here is my thought, please correct me if I am wrong.The cloth will float so if your resin is slow enough to...
Where can I purchase this epoxy your speaking of?
I am repairing a boat and using Nida Core for the sole. I purchased 25MM with 18oz wet laminated panels for the repair. I was surprised that I was...
OK, I was able to free up the gummed up injector pump with some Formbys furniture refinisher and Gumout and get it running. I am now concerned...
I decided to set this motor up to run occasionally on the stand since the boat repair is taking forever. I tried to start it and it fired right...