Would a laser not do the job including the math. I've used them for mechanical machinery but not for small marine applications. These items are...
It was not much so we sanded lightly and applied another coat. Sterling says recoat time max 24 hours before sanding is needed. We are in a cold...
Not sure where to post this. I put on my first coat of High Build epoxy primer on a aluminum hull and have a couple spots with orange peel....
Fast Fred The Cummings QSB5.9 common rail engine is one of the most modern and QUIET engines on the market. You must be thinking of the old...
Jack Frost I am using this drive on my boat. Of the manufacturer's that I have seen this one seems to stick out less than the others. My use is...
English Wheel Graham emailed me the plans for his english wheel. All I did was ask him for some information on it and he sent me a dwg. of the plans.
Seems the CWB in Canada doesn't approve 5183 filler material.
You can get a wealth of information on both of those engines at boatdiesel.com Both are good engines. I think the QSC8.3 490hp low idle is...
I have building a 48 cubic foot aluminum diesel fuel tank approx 5ft x 5ft top 2ft deep at center and follows the bottom V shape. (360gallons)...
Yipster I guess your thoughts are "Weight is always an issue" I suppose then that an anchor is not about weight it is design. In that case I would...
After further review I get it now.
SQ I looked at what you sent. Can you sum it up for me. Im not that technical. Thanks.
I will be welding 5083 aluminum plate soon. My supplier says he stocks 5356 for the local builders. He says 5183 is better but doesn't stock it....
That it is.
I think Seaboard Marine has done this before and probably could ship you a package all made up to drop in. Give them a call. Probably would have a...
I thought tigs were too hot to use on aluminum due to warpage of the sheets?
Willallison The Konrad Drive has this type of connection. http://www.konradmarine.com/products/520_installation.pdf Does Bravo ect use this type....
Nice welds. I see you are using a Miller. Is it one of the pulse on pulse ones?
What would be cheaper? and what is a two speed prop. (could you provice a link)
How does this sound. Will it work? Cummings QSB 5.9 305 Wt. 1350lbs, ZF Drive 315lbs, Drive Shaft, SternDrive. Corpus Skipper suggests I could...