As has been recommended use an epoxy primer Awlgrip 545 roll on 3 or 4 coats (following recoat time window) sand all smooth with 320 grit Roll...
Guys I want to make and install a cockpit deck on my boat It is a 12 foot X9.5 wide area Would like to use Vinylester resin and hand lay up There...
I wanted to get some advise on spraying gelcoat webbing. I have used in the past but have not been happy with the results I used the percentage...
I have some small fish holds maybe 150 quart in size They are rectangular in shape and constructed of Corecell and glass I am looking for...
Thanks for the replies
Thanks for the reply It is fresh I was afraid of that What would you recommend to remove the wax ? I would use Acetone and a stiff scotchbrite...
I would like to know what is the recommended solvent to dewax a flowcoated Gelcoat surface to prepare for a 2 part LP paint, I plan to do some...
Sounds like your Gelcoat already has wax in it
Thanks for the input guys I will contact Paul
Hey guys Can you recommend an epoxy for bedding stainless steel fuel tank fittings in a composite fuel tank. Thank you
Hello I have a request to build a fairly large GRP hard top with a dimension of aprox. 8.5 feet wide by 10 feet long. For a 42 foot flybridge...
You should contact the supplier and they can give you the information you are looking for. I'm not familiar with the international marine paint...
Interlux Bilge coat works well for all but the metal parts
Gonzo - The Paint is Awlgrip Thanks for the feedback guys I did roll the paint for the nonskid and it did get heavy on the tape line in...
Hey Guys I was wondering what tips you have to share to accomplish super clean paint edge lines, particularly when doing a two color non skid...
I like the 3M Vinylester filler for gelcoat repairs Yes it's expensive but you can't beat the BPO hardener for speed of cure For big stuff I mix...
take Gonzo's suggestion scrape it off and give a good solvent wash with acetone or mek and some terry cloth towels, then sand it again sorry...
I would recommend to thin your gelcoat 10 to 15% They will tell you to only use styrene but in my experience this will cause white gelcoat to...
You should look into having the deck Soda blasted to remove all of the old gelcoat I think you would be wasting your time to overcoat with out...
You know I was reading up on a bunch of different articles and came across those quotes Now that you mention it I think it was from an epoxy...