On a related subject- what does everyone say is the best epoxy for hand laminating heavy or multiple layers. What wets out best?
Sorry I did not make myself clear. The first problem is the gap between strips on the outside of curves. I though it would be easy to fill them...
I am glassing some hull extensions that are rounded, made of 3/4 corecell strips, flat cut, not bead and cove. Here is the holdup: The grooves...
OK Let's narrow it down- 45 foot bridgedeck cruising catamaran, 4 beds, 2 heads. This came to mind after looking at the diesel install on a...
There are a lot of different factors in selecting the engines for a mid 40's cat. How much hp? Where are we going to put them? What kind of...
Ghost Rudder? Did you ever get a rudder for your ghost? I might have one you can get for shipping cost.
What about gas engines? I was also thinking about a 3.0 gas motor (4 cyl) or a 4.3 V6- lots of them available that need rebuilding- I am assuming...
I actually am a Ford/New Holland tractor dealer so I would have to keep the John Deere motor a secret but does anyone have personal experience...
What are your thoughts on a 50hp approximate diesel? We are repowering a 1930 Elco 30ft cruiser. The main issue is quiet- yes we will isolate the...
I want to use a 401 Ford tractor diesel in a boat. The rear bolt pattern is the same as 2000 ford tractor thru 8000 ford tractor- Can i get some...
I am looking for a recommendation for someone to hire on an as needed consultant basis for a refurbishing job on a 1932 Elco Cruisette 32ft. It...
I was approached with the concept of putting all underwater gear, depth finder, knotmeter, thru hulls on a folding arm which would be faired into...
I would sure like to see what everyone has on their wish list for a cruising cat. I know some things I like but I am sure there are lots of things...
We have a Gemini 3000 that I believe is overloaded in the rear. However, I am not willing to give up what we carry. Last summer we checked boat...