Hi all I have a python drive p110t system installed Below is a link to what I have http://www.ap-marine.nl/index.php?page=p110-t I need...
Hi all, I have a prm 302d pretty much same as 402d and 500. I have a slight oil leek from one of the end caps on the gearboxs the buts up to the...
I Have a navman 4500 Fish and a navman chart plotter 5500 And also a navman VHF I would like to hook all these up so they can talk to each other...
Hi all I have just fiberglassed the bulk head of the cabin and need to gelcoat it. It is a large area and I would like the gel coat to be...
Hi I have a boat that has sealed decks with engine is half under the deck and rest in engine box. the boat is 31ft and has a 130HP engine. I...
Hi I have recently Purchased a mitchell 31 mk1 which i have been doing up. It didnt have a engine or any stern gear init when i got it, However...
Hi I am installing a new desiel engine in my boat and need to put in some fuel lines from the tank to the engine. I want to make sure i use the...
Hi I am looking to replace my current helm and steering cable as it keep slipping, I have replaced the bit in the helm but doesnt last long, the...
Hi all, Can anyone help I have got a Borg Warner V Drive Box and plate is only half there to identify the unit. I am trying to find out the...
Hi please see the pictures as you can see the shaft angle is rather steep well i think so anyway. I wanted to know what angle it should be or how...
I have Navman Chartplotter I want to link The NMEA Out put to My pc via RS232. I know you attach the nmea output from gps to input on rs232 and...
Ok Can anyone tell me anything about my hull. At present when i open her up the front lifts up quite high its like so close to getting on the...
Hi Everyone Ok attached are some pictures of the hull off my boat. Now can anyone tell me is this a plaining hull or displacment hull or semi...
I have a 22 foot semi displacment hull fishing boat with a ford transit 2.5 DI (approx 4000 rpm) engine init. with a 3:1 reduction gearbox. Thw...
Can anyone one advice me on the following I have a ford transit engine 2.5 65 HP which was on a volvo penta 270 outdrive the ratio on the leg...
I Have taken all the gell coat off the botom of my boat im down to just fiberglass Eventually when done i will be antifouling the bottom of the...
Hi can anyone one help I have osmasis really bad i started drilling it out however i came to the conclusions that i need to stip the gell coat off...