Hi all I have a python drive p110t system installed Below is a link to what I have http://www.ap-marine.nl/index.php?page=p110-t I need...
Hi all, I have a prm 302d pretty much same as 402d and 500. I have a slight oil leek from one of the end caps on the gearboxs the buts up to the...
I Have a navman 4500 Fish and a navman chart plotter 5500 And also a navman VHF I would like to hook all these up so they can talk to each other...
Hi thanks for the reply. I have white gelcoat which I have a wax additive i can add to make it go off and not sticky i guessing thats the...
Hi all I have just fiberglassed the bulk head of the cabin and need to gelcoat it. It is a large area and I would like the gel coat to be...
Hi I have a boat that has sealed decks with engine is half under the deck and rest in engine box. the boat is 31ft and has a 130HP engine. I...
Hi I have recently Purchased a mitchell 31 mk1 which i have been doing up. It didnt have a engine or any stern gear init when i got it, However...
Hi I am installing a new desiel engine in my boat and need to put in some fuel lines from the tank to the engine. I want to make sure i use the...
when i get the boat on the scrubbing pad i can make adjustments to make the steering better and a little litter, but i still need to replace my...
the shaft that the rudder is connected to goes into skeg at the bottom. i think as it goes into the skeg there is friction there. without major...
Hi I am looking to replace my current helm and steering cable as it keep slipping, I have replaced the bit in the helm but doesnt last long, the...
Just to let anyone know that if you are looking for part numbers and details of how many teeth are on specific drive gears have a look at this...
Great cheers Can anyone tell me the amount of teeth the gears have to which ratio? And if if i found out its not the ratio i would like is it...
Ok so that kinda ration would be more suited for a Ford D engine which is about 120hp at 2500 revs ??
Hi all, Can anyone help I have got a Borg Warner V Drive Box and plate is only half there to identify the unit. I am trying to find out the...
Hi all. I really wanted to get away from the outdrive leg because as i said it was always going wrong and a lot more maintinace than a shaft. But...
80hp is on FORD TRANSIT 2.5 engine if CDK is right and the angle is that steep does that mean that would be my problem? With regards my Revs i...
Hi sorry Guys lack of info on my part, My bad sorry. It was a 2-1 ration leg i think the prop was 16x15 and yes same engine. 80 HP. With regards...
yes me before i put a shaft on it i had a volvo 270 outdrive leg on it which did 14 knots with 80 HP. But i was always having problems with the...
where the prop comes through the shape of the bottom of the boat changes and yes it goes flat but that is how the boat was built i didnt change that.