yes america is a differant kettle of fish New Zealanders use there boats alot and are very hard on there gear we have a little alloy boat with an...
Auto motive diesels have a very easy life once a vehicle has reached its desired speed you can throttle back and barely use 25% of its HP,...
I know what you mean, there is no way of checking that the check valves are in good order but im sure 2x check valves and 300mm above water line...
The turbo will sit approximately 300mm above the water line, do you think I will need to extend the factory exhaust up higher; I will be using 2x...
thanks, yeah i had thought of that, the engine room air intakes are on both starboard and port sides right at the rear i was think of blanking the...
thanks a good point exhaust hose would keep vibration down I didn't think of that, so you guys would just run it from the riser straight out the...
Scary well ill try not to put into a situation like that lol but sometimes these thing just happen. I think the exhaust will look much nicer out...
yeah that sounds like a good idea, I think i can handle something like that, where can i find some info on wiring up such a useful gadget?. Ok...
I am not sold on putting it under water yet, is there a safty issue with the exhaust going below the water line? i can't see how, as the factory...
Noise was my reason also for putting it below the water line, since we will be at displacements speed quite often thought it would be nice to hear...
The engine will give us a cruise speed of 20-22Kts and a top speed of 27-29Kts we are not going to water ski with it LOL but will do us fine....
Im converting a carver Montego 27 from twin 4.3 V6’s to a single Diesel engine and I need to design and exhaust for a Volvo AD41a 3.6L Diesel...
My father and I are refitting out a Carver 27’ Montego And now we have reached the engine, we have removed the OMC King Cobra 4.3 V6’s and legs...
Wow no replies, well today I got the gas out and near fried the rubber coupling, but then with a hydraulic jack between the bob tale and the...
I'm preparing to remove the 1989 OMC Cobra V6's and legs so I can start laminating and cleaning up in the engine bay for a single Volvo conversion...
Really im in New Zealand is that a problem, is there any where i can buy it online Thanks for your help
Thanks, ill try to find a local dealer. As for the HP I don’t care about how fast I can go as long as I can cruise on the plan at relatively...
After a lot of thought I’ve decided to purchase a AD41 (Turbo 3.6L 200hp inline 6cyl 520kg with leg) I am convinced this engine will pack enough...
I can’t find anything bad about the marine 6.2 and it would fit nicely (might have to cut into and reinforce the two center stringers) also comes...
Thanks guys, well still so many paths to take and I have been thinking about buying a new stern leg (bravo 2). I don't mind playing with old gear...