We want to extract a lumpf of lead from a keel, the lead is supposed be casted with lead/antimon. I know from my active years that the chain saw...
In the early design concept stage the client is investigating into : Mono or cat, a lot is in favour of mono, less height etc. But what would be...
I have a boat here (open Poweboat) that exhibits gelcoat problems; it's lying south and has a black gel coat!! And a black boat cover as well,...
Hin all, I am looking for a current design or model being sold (not second hand) that features the specs of the Princess 385 flybridge, flat...
I am looking for the make and model of this boat, i cannot find any hint on the boat. it has got a Bladt Diesel and a wooden Mast, a quite small...
We are looking for a perspex windscreen of the proposed dimensions, we will install the windscreen in two half so even wider screen will qualify...
We are looking for a minimum height engine/drive for a fast power boat with moderate V. The cockpit layout shall be without stepos, the design...
Is there anybody out there who knows about the efficiency of using the prop/shaft to extract energy for the trolling prop while sailing. The ship...
I am looking for a utility vessel supporting regattas, I did the attached preliminary but the first estimated building cost did not please the...
I have heard about problems fastening aluminium fittings on carbon structures when not paying attention to correct insulation of the fasteners....
we all have our own calculation spreadsheets for keel bolt diameter etc. so perhaps there are spreadsheets around for the ISO Standards - anybody...
we are designing a canting keel with 480kg ballast and are looking for hydraulics and electronics to move the thing - have you got experience -...
my first canting keel boat on the drawing board. there are different ways to attach the bearings of the canting axis to the load carrying...
I am looking for an designer/engineeer to support me, a successful applicant will: Work with classification rules and ISO standards Produce...
I Am about to change program environment and therefore looking for above programs with associated licences. Klaus
dear all, we are about to design a shallow draft (o.6m) ferry of 22m loa. top speed to be obtained 20 knots, service speed 16 knots we are...
about two years ago i saw a rendering of a new open motorboat with a quite blunt bow (Deck view) design, it was very modern, does anybody know if...
Is the Paper on tunneled Props by Blount "Design of Propeller Tunnels for High-Speed Craft," FAST '97 worth bying the whole CD (560 Euro)? Does...