is it possible to add a hydraulic steering system to a 350 260hp I/O and to do it cheaper than these systems that seem to cost around a grand?
can anyone give me an estimate of how much belowdeck foam i need to order for approximately a 6 ft. section from the transom forward in a 21'...
i'm looking to get one of those boat dollies for easier moving aroud in tight spaces. I have a 21' Renken bowrider, does anyone know if a dollie...
yep, that sounds like them
haven't tried putting water in there yet, just pulled up the decking in front of the engine and saw how soaked and rotten some stringers and foam...
I just cut up a section of decking in front of the engine due to it being rather spongy, I was also hoping to see anything that could help answer...
i am doing all of my upholstery from scratch (21' renken bowrider). can anyone recommend where to get the vinyl and foam for the cushions. any...
how do i determine if the problem with a non functioning fuel gauge is a problem with the gauge itself, the sender, or somewhere in between?
i know i've already asked this once, but i didn't get a satisfactory answer, so i figured i'd give it another shot. I am currently dealing with...
ok, the dumb beginner has another major question. i am putting back together the MP 350 ANI (260hp, chevrolet block, 1991), don't ask why i took...
after i initially get it going in forward, then i can throttle back to a pretty slow speed i guess (can't remember right now). once i get it going...
is there any important difference between top side paint and regular auto paint? what i'm asking is if i repaint my topside with auto paint and...
marshmat, dunno how to answer most of your questions, but as far as putting it into drive, it works fine, i just have to throw it pretty far...
i'll have to get back to u on that info, pretty dark out there right now and i don't have the info on hand right now. i really appreciate the help...
looks like there should have been a nut, but really doesn't matter, can't knock it loose to save my life
pics ok, here goes a shot
how did u put a pic on?
how do i post a pic?
as far as corpus skipper said, there is not nut to run out, wheel is flush with the shaft, i have placed a random bolt against shaft and hit it...