Thank you Gonzo, I went to this site but this link looks like just the speakers. Isnt there a unit that needs to go inside with the...
Sorry I meant to say without digital screens. Just simple. With hopefully two functions. Barking orders to guys on deck of barge and a...
not really sure what that answer means.... But we are just looking for a very simple loudhailer possible with a horn to warn people. Just...
Hello All, We have a small barge ( 20 by 50) that we push with 24' pushboat. Only on freshwater protected lakes. I am looking for a very...
Hello All, Well I am back at it for a little bit. Had to get a barge section I was building out of the shop so I could get this boat in there....
the best I can see is Morse rack single cable? http://www.jamestowndistributors.com/userportal/document.do?docId=691
Hello All, Ok well I spent some time trying to track down the propeller. Very difficult to find. Looks like I will have to get one made....
Thank you very much for all this information. So really the first step ( and easiest) as a trial would be to find a 24" by 13.5 inch 4 blade....
I will go to shop and see if I can find exact part number on steering. and take some more picutres.
Is there such thing as duel manual steering? Using the same system of cables and u-joint like I have now? Might be a silly question. I was...
Hello All, Andy thank you very much. That was a great reply. So would I be best to order the same ( or similar) morse controls as the ones...
other questions Ok sorry to keep going on. I would like to build a fly bridge as well to land when bins and machines are on to see better....
boat has keel coolers welded on bottom. Long aluminum pipes ( 4 total) that coolant runs through. Exhaust manifolds also run coolant. The...
More questions on converting the workboat Hello All, I am sorry with all the questions.....sadly there will be many more. And again I...
Hello Again, Thank you so much for all the help. We are starting work next week and another question has popped up. We are going to install...
Hi Sam, Thank you very much for all that information. I have to head out and barge a load this morning then I am going to look over the boat...
Thank you gentlemen this is a great learning experience. The nozzle setup looks like it would be a nice setup. Can these be purchased through a...
Hi Sam, Thank you very much. I will try the other screw to see what is in there. If the cutlass bearing has sat for awhile do they dry out and...
more photos more photos I wanted to make sure this was working. Any thoughts on this small rudder and handling at slow speeds? I know...
Hello All, Well I have let this boat sit for a few years now. But of course now we need it quickly. Further to my other posts here is all...