hello! I would like to apply epoxy over resin over polyester gelcoat. I have seen several instructions on how I should do it. Degrease first, then...
Hello! After I removed the part from the mold, these marks always remain on the mold but also on the part removed from the mold. The waxing...
Hello! I would like to laminate 2 layers of 150g/m2 CSM and 6 layers of 450g/m2 CSM with polyester resin in a mold. I would like to laminate two...
Hello!I want to coat an ABS plastic with epoxy and I want to know the steps for the best adeshion between those tow?Thanks
Hello again! The mold came out well and so did the part from the mold! But after I removed the part from the mold, various stains and traces from...
Hello again! I have a question! I want to make a part in the mold! The first layer I want to be a gelcoat and then start the lamination with CSM....
Hello again! I removed the mold from the plug and it has scratches because the plug was not prepared very well! What should I do? Should I wet...
Hello! I used tooling gelcoat for mould production. I applied a first layer onto the plug with 2.5% MEKP with a brush and let it harden overnight...
Hello! I want a question! I want to make a mold and let's say I want to make 1000 pieces off the mold with a thickness of 4mm! How thick should...
Hello! I want to make a fiberglass part in a mold and I need the final thickness to be about 4mm! I don't want the first layer to be gelcoat...
