I have a project for 17m Tour Boat with maximum draft of 0.4m and single shaft with propeller drive. Looking at the previous boats owned by this...
Can anyone advise whats considered a safe height of the underside of catamaran between hulls. This is a 6 kt lake boat so not much in the way of...
I would just like to find some opinions regarding bilge pump switches. For some reason nearly all bilge pump switches have an off position..why ?...
I'm looking for the pvc coated nylon guard lines they often use on sailboat deck rails. I remember using them many years ago, it was an outer pvc...
Looking for a designer or design company with extensive portfolia of Aluminium vessels ranging from 14m workboat monohulls to 80m fast cat ferries...
Aluminium boat, the paint has gone milky after 2 years in patches also Orange Peel(Guess thats always been). Any ideas on cause of this problem...
Hi, Finding information on exhaust system for self righting vessels is proving very difficult. Looking at how best to configure the system on...
Molds for sale...Unique opportunity to purchase mold tools of highly respected Brand, 60' aft cabin flybridge cruiser...tools located in UK. This...
I know over the years there has been a lot of theories and questions regarding bonding systems on Aluminium Vessels. I would like to know if...
Hi, how do i wire for bulb failure indication on navigation lights ?
Hi, anyone please advise a good software for electrical drawings ?
Hi, Anyone come across this problem...Large Bilge pump self priming centrafugal runs fine until its actually pumping water then it vibrates...
Hi, Have a large aluminium sea strainer which has to be coated inside because of the S/steel mesh filter, any reason why it cant be an...
Looking for experienced designer with a current design for 14m work boat. Basic requirement for vessel as follows..Rescue aid in coastal waters,...
Hi, Reading a spec for new build quote and this baffles me.. This 35m Aluminium Cat has inboards with conventional rudders and the basic...
Hi, I have a customer requesting "Engine Air Inlet Fans proportionately conrolled by engine rpm". Anyone help on this please ?
