Xanthetsy To bond surfaces in maxsurf they must have the same number of control points and stiffness. The bad bow surface was that it got...
If you think the jumping croc is big you should of seen what took his right leg!
HHBILL I have been doing some projects lately where Line drawings were used to create surfaces/meshes for 5 axis milling and printing. It is...
The problem is the trimmed surfaces in the pic barge rebuild 1 I have turned on the control points for the fillet edge as you can see the red...
Xthesinos have a look at this maxsurf file imported from rhino after I changed some of the surfaces to different types. I then did a little work...
Xthesinos Importing trimmed surfaces and things like fillets into maxsurf never really, if ever, works well, you are far better off to build your...
http://www.sealegs.com/ They fill a need.
Newranni
It maybe better to treat the transom as a separate surface and split the waterlines at the corner
Chirpingler If you are using loft use the “tight” style to get a better fit. As Tansl suggested “offsetsuf” also you can put in a temporary...
Intotheblue when you say “set up grids” are you talking sections, waterlines and buttocks etc. or control points, columns and rows
you could start here www.youtube.com/watch?v=3XkdIsleAqY
Goldhunter 2 just open it and save it by another name
here is the file
Goldhunter 2 what version of maxsurf do you have. I have a 3 surface generic tri hull which you could adapt.
Then “John Keats” should have designed boats, from his tombstone "HERE LIES ONE WHOSE NAME WAS WRIT IN WATER".
Rhino, 15 minutes, two cones, a bit of slicing and dicing and …........
google bruce number and you will get a calculator for that
